Scanning Node is programmed with device Type and transmission type as 0 -Įnabling it to receive messages from all nodes.Ģ. Node? (0x4E, 0x5D.?)Īlso, what is the format of the message that will be received by Master Nodeįrom the Scanning Node in response to the message sent by Master Node?ġ. What is the ID of the message that should be used to send messages from Master Node to scanning Node. For every message that is sent by the Master Node, I want to send back a message from the scanning Node to the master mode.ģ.
In other words, if this command is used, then the ANT will always send the channel ID based on the serial number to the scanning Node ?Ģ. If I use the message 0圆5 to set serial number as channel ID, do I have to add device number based on the serial number explicitly or ANT system will add the serial number as part of the message sent to scanning Node. I want to use serial number as the device number in the Master NODE for channel ID and have scanning Node to use this ID to send messages back to the corresponding Master node.
I am using ANT AT3 modules for the Scanning Node and Master Nodes and adding an additional processor to communicate with these nodes over the serial channel.ġ. Scanning Node to keep track of the master Nodes (recording the serial number/channel ID of the Master Ant Nodes) visiting the area of influence of Designing a simple system consisting of a scanning Node (fixed location) and roaming nodes called Master Nodes that roam in and out of the area of Scanning Node.
0 kommentar(er)
